Use the scissor lift outside only when weather conditions are good. Scissor lifts rated for outdoor use are generally limited to wind speeds below 28 miles per hour. … Never allow equipment other than the scissor mechanism to be used to raise the work platform (e.g., using a forklift to lift the work platform).
Can a scissor lift get wet?
Wet conditions mean slippery conditions for both the wheels on your scissor lift hire and for the staff working on them. As most access equipment is made primarily from metals such as steel, when these surface materials get wet, there is very little traction for those on board.
Do you need to be certified to use a scissor lift?
Scissor Lift Certification Training. … To operate scissor lifts safely and avoid serious workplace accidents, however, all employees who work with or from scissor lifts are legally required to complete OSHA-approved operator certification and safety training classes, and that’s where CertifyMeOnline.net can help.
Can you use a scissor lift to access a roof?
Answer: OSHA standards do not prohibit employees from exiting or entering an aerial lift basket that rests on or adjacent to an elevated surface. … Section 1926.453(b)(2)(iii), which prohibits “belting off to an adjacent pole, structure, or equipment while working from an aerial lift,” does not apply to scissor lifts.
Is a scissor lift an aerial work platform?
There are numerous types of “lifts” used in industry, and it can be confusing for employers. Per OSHA, a scissor lift is a mobile scaffold for which the platform only moves vertically. An aerial lift is any vehicle-mounted work platform that can move vertically and/or horizontally.
How many hours does a scissor lift last?
A scissor lift will only count the hours as it is in motion, so if you are hanging drywall or doing electrical, it’s not counting those hours. So, we would say that a scissor lift can last about 500 to 1,000 hours of movement.
How fast does a scissor lift go?
Maximum speed of 3 miles per hour lowered. Large 65-inch by 115-inch platform. Oscillating axle for efficient maneuverability. 33-40-foot extension height.
Why you shouldn’t wear a harness in a scissor lift?
For instance, if a scissor lift operator is wearing a harness and goes over a lift’s guardrail, he or she could inadvertently create enough force to cause the machine to tip over. In this scenario, the operator could put himself or herself and bystanders in danger.
Can anyone operate a scissor lift?
Yes, you do. Scissor lifts can be dangerous and can cause accidents leading to personal injuries as well as structural and equipment damage. Current regulations state that all personnel who work with or near scissor lifts must be trained and licenced.
Do you need a yellow card to operate a scissor lift?
There is no requirement to hold a WP High Risk Work Licence to operate a scissor lift. … This card will provide you with proof that you have been trained in the operation of a scissor lift. For more information on the yellow card program click HERE. For more information on licencing requirements Click HERE.
What is the OSHA standard for scissor lifts?
While there are no OSHA provisions that specifically address scissor lifts, they do meet the definition of a scaffold (§1926.451 – general requirements for scaffolds). Employers must therefore comply with the other applicable provisions of Subpart L when using scissor lifts.
Do you have to wear a harness in a boom lift?
“A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift”. It is important to note that as of January 1, 1998, body belts are no longer acceptable as part of a personal fall arrest system. A full body harness is required.
Can you use a scissor lift as an anchor point?
Other forms of fall protection are not allowed in scissor lifts, as the force of an employee falling out of one could potentially cause a scissor lift to topple. Therefore, it is not a suitable anchor to arrest an employee’s fall using a personal fall arrest system with a deceleration device.
What is the difference between a scissor lift and a boom lift?
A boom lift is a type of aerial lift, but it provides much greater flexibility than a scissor lift. This is because it is supported by a hydraulic arm that is capable of maneuvering around obstacles. Boom lifts can also extend to higher elevations.
How often is scissor lift training required?
Per OSHA aerial lift training requirements, all new employees require aerial lift & scissor lift training. Every three years, your employees need re-certified, and CMO offers this for free!
Is a scissor lift considered a scaffold?
Scissor lifts are mobile supported scaffold work platforms used to safely move workers vertically and to different locations in a variety of industries including construction, retail, entertainment and manufacturing.